Proportional Dosing Fluid Driven Pump

Specifications 2 - Water Proportioner Operating Conditions: Flow range: 5-2500 l / h Water temperature: 4 C -35 C Working pressure: 0.5-2.5 kg Outlet drug concentration: 0.2-2% adjustable   Installation and fixing of the dosing device: 1 Select location: The inlet and outlet of the dosing device must be consistent with the inlet and outlet of the main pipe. 2 - Dosing device must be in accordance with: Dosing device on the liquid suction catheter under the method of installation 3 - Fix the dosing device to the wall or secure it to other facilities. 4 - the dosing device and the outlet in accordance with the direction of water installed to ensure its confined. 5 - Install the 100-120 mesh filter between the inlet of the water valve and the dosing device. 6 when the need for dosing time to close the dosing device side of the valve, open the dosing device on both sides of the valve can be dosing. 7 When the dosing device starts to work, you will hear a click, then press the dosing valve at the top of the valve, when a small amount of water out when the release can ensure that the normal work of the dosing device. 4 Dosing the main application areas: 1 - Horticulture industry: flowers, fruits and vegetables and other fertilization, storage, pest control 2 - Livestock industry: chicken / duck / cattle / pig and other livestock and poultry health care than the three industrial areas: water treatment, chemical, metal processing, fire And other industries 4 in addition to taste / cooling / lubrication and other special solvent than the dilution; widely used in beer, beverage industry chain lubricants to add equipment, disinfectant to add equipment and beer bottles, beer fermentation tank cleaning equipment on the 5- Other industries: car wash / print / hospital / wine and so on 5 - Dosing device to adjust the use of the ratio: Dosing device can be adjusted according to the actual situation in the injection of water in the proportion of additives, so that the effect of the best additives, the specific method is as follows: 1 Loosen the screw and remove the U-type adjustment lock from the top of the dosing device. 2 - Proportion of liquid additive and water according to the ratio of water scale on the dosing device: Counterclockwise adjustment is to increase the proportion of liquid additives. Clockwise adjustment is to reduce the proportion of liquid additives. The percentage of the dosing device is based on the final effluent of the dosing device. 3 Turn the adjuster until the U-shaped adjustment hole is inserted into the slot of the applicator. 4 Push the U-shaped adjustment lock into the slot on the dosing device until it is fastened to each other.   6 Note: 1 When using automatic dosing device, make sure that the container containing the liquid additive is not empty! 2-vent valve: At the beginning of the start of the dosing device, you should press down the vent valve for a few seconds, drain the existing air, this process will have a little water out, after the discharge of air, quickly off the gas valve. 3 to install and use the process to ensure that the applicator inlet must be installed filter equipment. Next to the main pipeline, the hydraulic drive does not require additional power, will not cause the main pipe on the pressure loss.