Conveyor Belt Control Panel by Friction Free Instruments Private Limited

Being a most reliable organization, we are engaged in offering a wide range of Conveyor Belt Control Panel.

Other details:

• In order to cater diverse requirements of the clients, we offer an exceptional array of Conveyor Belt Control Panel that is fabricated with perfection
• We offer them with advanced Phase indicating lights and have Main flasher/audible unit located on the top part of the panel to indicate an alarm condition on any equipment
• The panel incorporated with all the necessary equipment, including motor rated MCCBs or MCBs, contactors/ starters with overloads, start/ stop buttons, run/ trip indication, speed indication, hand/ off/ auto switches, auxiliary contacts, relays, insulated transformer, means of isolation, wiring etc.
• Lamp test facility
• Lockable isolating handle
• Trip alarm indication inside the panel via adequate 24 volt relays with remote audio/visual alarm
• Phase failure unit
• Emergency stop push button allowing manual shutdown of the complete panel
• Complete shutdown of the panel upon receiving a signal from the Fire Alarm Panel interface
• Control circuit with MCB, ‘On’ lamp, insulated transformer, relays, etc. for the control circuits necessary
• Interlocks as per the controller detailed instruction and as may be necessary for the safe operation of the equipments

Specification:

• 16 channels as a standard output. Higher or lower number of output channels may be provided on request
• Sequence starts from 1st Channel Motor then it moves to 2nd Channel Motor and carried out up to the last channel in pre programmed Time duration between 1 to 9999 Sec for each channel
• Display: ½” high, 8 Nos of 7 segment Red LED display
• Output: 1 NO Relay contact per channel
• All output contacts are rated for 3 Amp. @ 230Vac on resistive load, higher load capacity achieved by the way of activating Contactor by using the relay output available within the controller
• Operating Sequence: When the system is in the start mode the operating sequence of the output Load or motors is from first to last channel and if it is in the stop mode the operating sequence of the output Load or motors is from Last to First channel
• Remote Start: The remote NC contact provided for sequence to start
• Remote Stop: The remote NC contact provided for sequence to stop
• Channel Skip Facility: Unwanted channel can be skipped through programming